yea 7C was idle.... when i tested the cpu at 100% it didn't go above 45C and when i tested it at full load with my old HSF it went to 67C... so a...
Well i got the thermalright today and it came with the fan attached to it.. I didn't think it was going to be that big lol.. but besides that it...
well when i went to ncix.com they had 2 options.. the thermalright without a fan and the thermalright with a fan option.. so i chose the fan it...
well thx for the info but i already ordered that thermalright but if its to loud for me i'll end up replacing the fan part.... ty
yea so thts the best way for me to find out the limits of my cpu right? right now ive been using synced which puts my mem down to 667 and i can...
k yea i dont really plan on messing with memory much.. but with the unlink option it is there and than you can adjust the fsb seperate from the...
no its possible i did it and i looked at my motherboards guide to overclocking and in it they say it to.... so i think that would be my best...
I have been reading on the way to overclock my board and there are 2 options.. i can do linked/synced... wich will give me the 1:1 ratio but as i...
which one do you think is better??? NCIXUS.com - Buy Thermalright Ultra 120 Extreme 6 Heatpipe Cooler LGA775 Heatsink 120MM Fan 1000RPM 15.8DBA...
Ok now i got it in the 1:1 ratio... on my motherboard it has set ratios 1:1 5:4 3:2 ... and than it has synced mode.... now when i put it to 1:1...
on my motherboard all of the speeds arent base speeds so the mem shows 800 the fsb shows 1333... i looked over a guide for the motherboard and it...
ok now i put the ratio to 1:1 and i got a warning error on the post test and it told me to go back to the bios to fix the cpu speed. now...
I have been having trouble understanding the ram dividers and how it all works.. also not sure about what it is to exceed mhz.. in other words a...
ok i think i understand now that my fsb should be at 1600 will give me a 400 mhz cpu will give me the 3.6 ghz and my ram being pc26400 will now be...
Hey sorry for being a pain loll just trying to understand all of this best i can. Thank you for all the reply's and help. When i raise the FSB to...
yea ive read that article and gotta read it again.... so correct me of im wrong... first when you guys say take it in +10 mhz increments you mean...
I might be completely wrong here.. but i was looking at how the ram works with its latency and how you can figure out how fast your ram will run...
The way i overclocked my cpu was changing the fsb from 1333 to 1372 wich than gave me 343 mhz instead of 333.. my ghz went from 3.00 to 3.08 ......
I am new to overclocking and read about it for a while. Havent done any of it yet but read articles upon articles.. I dled the cpu-z program and...
Separate names with a comma.
